NEW Doug Fleenor DMX To AMX Converter: 96 Channel 0 - 10 Volt
Description
The DMX to Analog Converter decodes consecutive DMX512 channels to 0 to 10 volt output. Two versions are available: 24 and 96 output. The starting address is selected by an easy to read (and set) three digit push-wheel switch. The switch is mounted on the front panel along with power, signal, and output 1 mimic indicators. The DMX in and through connectors and the female DB-25 output connector(s) are located on the back panel.
All connectors feature gold plated contacts. The output pinouts are easy to remember: each pin number equals the channel number, and pin 25 is common. The DMX512 input is optically isolated from the outputs and is protected against miswiring up to 120 volts. The (defeatable) hold feature holds the last look indefinitely upon loss of DMX. A test feature allows you to bring any output to full by setting the front panel switch to 601 - 624 (601 - 696). The converter may also be ordered to receive Colortran's CMX protocol.
NewLighting.com is proud to be an authorized dealer for the top manufacturers of theatrical lighting and event equipment. Factory sealed items are shipped direct to your doorstep and include all applicable manufacturer warranties. All items are subject to availability.
Features
- Input baud rate: DMX512: 250 Kb/s, CMX: 152.6 Kb/s
- Input circuit: EIA-485 receiver with series 100 ohm PTC self resetting "fuses" clamped to +/- 7 volts by four low capacitance transorb diodes
- Input signal: 0.5 volts minimum, 12 volts maximum
- Input can withstand up to 120 volts without damage, transients up to 5KV
- Output circuit: LM324 quad op amp with 1N4004 series diode
- Output signal: 0 to 10.1 volts positive DC into 2000 ohm load, Outputs can withstand up to positive 400 volts without damage, Outputs cannot withstand high negative voltages
- Max. output current: 15 mA per output, 120 mA total all outputs (360 mA total on 96 out version)
- Input/output isolation: Greater than 500 volts
- Throughput delay: Less than .005 seconds (DMX input change to analog output change)
- DMX512 connectors: Two gold plated 5 pin Neutrik D-1 Series (male input, female pass through) (All five pins are wired on the pass through)
- Analog connector: Female DB-25 with gold plated pins. Pin number equals output number, pin 25 is output common
- Power input: 90 - 125 volts, 50/60 hertz, 10 watts (180 - 250 volts optional)
- Color: Silver anodized aluminum
- Size and weight: 8.0" deep, 1.7" high, 16.7" wide, 4.5 pounds (19" adapter available)
Additional Details
| Ships From: | United States |
| Manufacturer: | Doug Fleenor Design |
| Condition: | Brand New |
| Model: | DMX96ANL |
| Item #: | 6849 (4Wall/UsedLighting.com Owned) |
| Tags: | Amx converter, Dmx converter, Doug fleenor |
- (1) DMX To AMX Converter: 96 Channel 0 - 10 Volt
Shipping on all NEW Items is only $10 per order, no matter how large your order is!
Ships from: United States
